In the kitchen space, how to install the sink is very particular. Those with basic knowledge know that there are three installation methods for sinks, namely, on-stage, Taichung, and off-stage. However, not every sink can be installed in these three ways. The following Handmade Sink Manufacturers will give you an introduction:
- One-piece stretching groove
Because of the angled edges of the integrated sink, it is difficult to install the under-counter basin. When installing by a poorly skilled master, the corners will not fit properly. Unqualified installation will easily lead to problems such as degumming and water leakage. Therefore, it is recommended to install the sink with an integrated stretch on the platform or in the platform. If you think that the above counter basin will have clean dead spots, you can communicate with the master in advance to make the Taichung basin, and then seal the waterproof glue around it. This is not only easy to clean, but also very beautiful. - Manual slot
The manual groove is welded by steel plates. The thickness of the groove body of the manual groove is uniform, and the edge is smooth and beautiful. All three installation methods are applicable. Moreover, the craftsmanship of the manual tank is special, and the edges can achieve small R angles and vertical edges, which increases the cleaning space inside the tank body, which is more atmospheric from a visual point of view. - Quartz stone sink
The quartz stone sink is heavier as a whole because of its thick sides. It is recommended to install an over-counter basin. Single slot may be considered for under-counter installation, but it is more challenging for the master’s craftsmanship, and the bottom needs to be reinforced, otherwise it will fall off easily, which is dangerous. However, whether it is single or double tank, Taichung basin cannot be installed.
Through the above introduction, Stainless Steel Kitchen Cabinets Manufacturers hopes that you can simply refer to the content of this article in future use.
