Flower Pot Mould is one of our products, here are tips to reduce mold cost. One of the most common reasons for using plastic in tools may be to reduce the manufacturing cost of plastic flowerpot molds. The following suggestions can usually help minimize costs:

Simplify flowerpot mold design. The mold design consisting of text descriptions and sketches and part printing eliminates the need for complex, full-size drawings and may be the first step in reducing costs.

Use existing models or parts. Since plastic is essentially a copy material, there must always be a shape, except in special circumstances. Plane runout is the easiest to construct and should be used whenever possible.

Eliminate all undercuts and loose fragments as much as possible to simplify shape reproduction. Use lattice type laminate. Whenever possible, a lattice-type laminated structure should be used instead of a solid structure. The lattice structure requires less material and less labor, and is lighter.

Choose the support structure carefully. Each type of support structure is good for a specific type of tool. Wood is fast and has the lowest cost, but its dimensional stability is relatively poor, and its weak links are clear. The manufactured plastic support structure may be expensive in terms of materials and labor, but light in weight.

Filling is used in the material of the plastic flow pot tool. In situations where relatively large amounts of plastic are required and strength is not critical, fillers can increase the yield of relatively expensive plastic materials.

Large flat tool area of the pot. By pouring the surface from the panel to the gasket, rib or the entire continuous surface, slow and expensive processing of large areas can be eliminated.

In addition, Pitcher Mould is also one of our products, you are welcome to buy.